WIRELESS RACING TRACK SENSORS

COMING SOON ! Please DO NOT order till we remove this line, Still under development !

DIA has done what no other company in the world has done !  The Worlds only Wireless Racing Track System (WRTS) with up to 12 Channels and the lowest power consumption around. Our Wireless Racing track Sensor System is an Add-on to our DIA main unit, the WRTS Base RX sits on top of the main DIA unit, and you simply plug in the 4P4C Data cables in to matching ports. The WRTS is powered by the main DIA unit so no other power source is needed. You Must use a minimum of 2 x Wireless TX Sensor Sending units (PRE-STAGE/STAGE & Finish) to allow the WRTS to operate. You can mix both wired & wireless sensors with the WRTS. A RED LED light on all units will indicate when a SENSOR is NOT Aligned correctly.

The system uses a Low Frequency prototypical of 433mhz for sending detected signals from the IR or LASER Track Sensors and sends that signal to the main RX Base hub.The Track Sensor Transmitters use 2 x AA rechargeable batteries and the Solar panel on the units will keep the batteries charged, but we do recommend charging with a NiMh Charger (sold separately).  Next pick the number of Wireless TX Units you wish to use on your track. 1 TX unit will accept both L & R Lane IR or LASER Detector sensors. Example: For a 1/10 Scale Drag Racing we recommend SET #1 which includes: Main Base RX Hub, Pre-Stage-Stage, 60ft, 1000ft, & Finish TX sensors. You will get 1 x Wireless TX unit per each selection for R-L lanes. You will need a 1000ft & Finish sensor if you wish a “SPEED TRAP” at end of track, otherwise the DIA unit will use the STAGE & FINISH sensors to give a estimated MPH/KPH. If you wish the whole package (recommended): SET # 2 -Includes Base TX Base Hub + 2 x Wireless TX units. If unsure how to use this system please click HERE for description page.